PRODUCTS

Magnetic chucks, for grinding

These chucks are ideal for grinding different kinds of pieces, and give good results with small, narrow pieces.

They are completely coolant-tight and oil-tight and can operate totally submerged in these liquids.

Magnetisation is carried out via the lever, and chucks with lengths over 600 mm have 2 levers. The shaft on smaller chucks does not project from the chuck and can be handled using the Allen key supplied.

The clamps used to hold the chuck are supplied separately and must be ordered expressly.

Available in two different pole spacings: Nor-Pol and Fi-Pol.

NOR-POL

Pole spacing of 6-5 (6 mm of steel and 5 of brass).

It is suitable for all kinds of pieces with thicknesses as small as 2 mm to the very largest pieces.

Clamping force: 100 N /cm²

FI-POL

Pole spacing of 6-5 (6 mm of steel and 5 of brass).

It is suitable for all kinds of pieces with thicknesses as small as 2 mm to the very largest pieces.

Clamping force: 100 N /cm²