PRODUCTS

Demagnetisers

These demagnetisers have been designed to remove the remaining magnetism from the pieces after having been in contact with a magnetic field.

Demagnetisers tabletop models

This demagnetiser is ideal for workshops as it removes the remaining magnetism from components, tools, screws, bearings, etc. The piece to be demagnetised should be passed over the device.

This model is not designed for continuous use and cannot be connected for more than 10 minutes at one time. It has a thermostat that disconnects its when it reaches the maximum permitted temperature (70ºC); it cannot be reconnected until the temperature has dropped to the permitted levels.

Input voltage: 220-240 V / 50-60 Hz.

Demagnetisers portable model

This model is used to remove the remaining magnetism from large pieces. The device should be passed over the piece manually.

This demagnetiser is not designed for continuous use and cannot be connected for more than 10 minutes at one time.
It has a thermostat that disconnects its when it reaches the maximum permitted temperature (70ºC); it cannot be reconnected until the temperature has dropped to the permitted levels.

Input voltage: 220-240 V / 50-60 Hz.

Demagnetisers tunnel models

This demagnetiser is designed for continuous use, it can be connected permanently.

This model is suitable for automatic processes where there is a flux of material. The pieces to be demagnetised should be passed through the inside of the device.

Input voltage: 220-240 V / 50-60 Hz. Other voltages on request.

Customised models and measurements on request.

Continous service demagnetisers

To remove the residual magnetism that manufacturing process of serial pieces acquire.

It is necessary to remove the magnetism of these pieces to continue or finish the production, and for this purpose a CONTINOUS SERVICE DEMAGNETISER (wahtch video).